Winn Bearden in Americus, GA runs a RR/SIII hybrid. Rover V8 engine on 100"
RR frame with stretched 88" body. Nice rig.
Winn, you copy?
----- Original Message -----
From: <Bradley_Harris@aigag.com>
To: <lro@koan.team.net>
Sent: Wednesday, February 05, 2003 1:59 PM
Subject: [lro] Series SWB Body on a RR Frame
>
> Anybody done this without cutting the frame down to 88 inches? I know I've
> seen vehicles like this in LRO. The ones I have seen in the LR mags were
> usually D-90 bodies. Even though the wheelbase went from 88" to 92",
aren't
> the bodies of the series SWB and the D-90 essentially the same (except for
> the breakfast, bonnet, hood and stuff)? Scooter - is my memory correct
that
> you were doing this? The end result would be a 100" series SWB with very
> little body overhang past the wheels. I am sure cutting and shaping of
> wheel arches would be required. I realize I could also use a LWB body and
> cut a little off the front and rear of the rear bed.
>
> Thanks,
>
> Brad H.
> _______________________________________________
> LRO mailing list
> LRO@land-rover.team.net
> http://land-rover.team.net/mailman/listinfo/lro
_______________________________________________
LRO mailing list
LRO@land-rover.team.net
http://land-rover.team.net/mailman/listinfo/lro
This archive was generated by hypermail 2b30 : Wed Feb 05 2003 - 19:38:08 EST