Hi,
I bought some gasket remover from the NAPA store. I think it was made by
Permatex.
Spray on and let it sit. Thick cardboard might soften a bit easier if you
nick it a bit with a knife so the stuff can soak in.
Bob B
At 07:54 AM 12/2/2002, you wrote:
>I removed the sump for a new seal and found that the old seal is held in
>place with some *MoD adhesive*, and that stuff is as hard as the steel
>sump! Last night I gave up after a few inches since I needed a better
>scraper. Then I thought maybe there is an easier way, like some sort of
>gasket softener/remover. Any suggestions? (Oh, and I don't think I have
>anything large enough for the sump to soak in.)
>
>Tom Proctor
>67 IIa 109
>_______________________________________________
>LRO mailing list
>LRO@land-rover.team.net
>http://land-rover.team.net/mailman/listinfo/lro
_______________________________________________
LRO mailing list
LRO@land-rover.team.net
http://land-rover.team.net/mailman/listinfo/lro
This archive was generated by hypermail 2b30 : Mon Dec 02 2002 - 11:23:12 EST