Re: LRO: cutting off bolts

• Previous message: Tim Czajka: "LRO: Re: cutting off bolts"
• In reply to: SJH: "LRO: cutting off bolts"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

On Fri, 20 Apr 2001, SJH wrote:

:but don't want to damage anything. I was thinking a cutoff wheel could
:simply slice down through the head of each screw to floor or washer level
:and a chisel would then make quick work of the head. Grinder (4.5 inch
:dewalt) just seems kinda slow.

Get a couple cut-off wheels for your angle grinder. They'll slice bolts off
right quickly. Watch the floor though!

-- 
dscheidt@tumbolia.com
Bipedalism is only a fad.

• Next message: TeriAnn Wakeman: "Re: LRO: OD nut torque setting needed - seriously"
• Previous message: Tim Czajka: "LRO: Re: cutting off bolts"
• In reply to: SJH: "LRO: cutting off bolts"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

This archive was generated by hypermail 2b30 : Fri Apr 20 2001 - 15:21:00 EDT