On one it's just a very small hole - seems I missed a spot with the POR-15
;) On the other there are some major patches needed - but wanted to buy
some time before I did a frame-swap on it.
> >
>I have since found replacing the whole chassis was easier than chasing the
>rust however, if you must repair a small section use the dimensions below;
>3mm or .125" or 1/16" or 16 gauge should work.
>cheers,
>
>Chris Johnston
>Slll NADA SWB
>Discovery SD 4.0
>Landrover Adventure Association Ontario.
>www.landroveradventure.com
>_______________________________________________
>LRO mailing list
>LRO@land-rover.team.net
>http://land-rover.team.net/mailman/listinfo/lro
_________________________________________________________________
Protect your PC - get McAfee.com VirusScan Online
http://clinic.mcafee.com/clinic/ibuy/campaign.asp?cid=3963
_______________________________________________
LRO mailing list
LRO@land-rover.team.net
http://land-rover.team.net/mailman/listinfo/lro
This archive was generated by hypermail 2b30 : Tue Apr 08 2003 - 14:50:03 EDT