What engine is it Brad?
John and Muddy
Bradley_Harris@aigag.com wrote:
>
> I am looking at starting the next step on my diesel conversion for my
> Series 3 109. Are there any resources out there that gives patterns or
> measurements for different bolt patterns for bellhousings? The engine I
> have is mated to many different vehicles in Brazil and other countries and
> I am not sure which transmission fits up to my engine. The engine has the
> timing gears in the rear and the area around the flywheel where the
> bellhousing bolts to unbolts. Different rear plates can be used to match
> different bolt patterns depending upon the application. Ford purchased the
> engine from the manufacturer so it might match a Ford bolt pattern.
>
> My next step would be to see if I can find a part number on the rear engine
> plate and contact the manufacturer and see if they can tell me what it is
> designed to fit. Or purchase a new rear plate to fit whatever transmission
> I want to use. The last resort is to just re-tap the plate for a
> transmission I want to use.
>
> Any ideas?
>
> Brad H.
> _______________________________________________
> LRO mailing list
> LRO@land-rover.team.net
> http://land-rover.team.net/mailman/listinfo/lro
_______________________________________________
LRO mailing list
LRO@land-rover.team.net
http://land-rover.team.net/mailman/listinfo/lro
This archive was generated by hypermail 2b30 : Tue Jan 28 2003 - 12:28:47 EST