If I were to make two bends in a golf club shaft (less than 10mm OD),
with each bend approx a 30mm radius, do I need to heat the shaft prior
to bending??? The bends will be at the tapered end of the shaft, where
the head is cut from the club. And yes, the sacrificial clubs will
become snake handling sticks. 8-0
Tom
_______________________________________________
LRO mailing list
LRO@land-rover.team.net
http://land-rover.team.net/mailman/listinfo/lro
This archive was generated by hypermail 2b30 : Wed Dec 04 2002 - 10:25:03 EST