--- Tom Proctor <t_proctor@daido.net> wrote:
>
> If I were to make two bends in a golf club shaft (less
> than 10mm OD),
> with each bend approx a 30mm radius, do I need to heat
> the shaft prior
> to bending???
I would - you're less likely to get cracking or stress
issues.
Heat it with a torch, then bend it over a mandrel. i do it
all the time.
ajr
=====
The journey is the destination. Anything else is illusion.
Please ignore the following advertising.....
Yahoo! Mail Plus - Powerful. Affordable. Sign up now.
http://mailplus.yahoo.com
_______________________________________________
LRO mailing list
LRO@land-rover.team.net
http://land-rover.team.net/mailman/listinfo/lro
This archive was generated by hypermail 2b30 : Wed Dec 04 2002 - 10:28:20 EST