Clear packing tape, put on very thick, seems to resist sandblasting very
very well. Just put a lot on, I suspect duct tape`s somewhat textured
surface gives the sand some purchas, incentive to tear it off...
I would simply blast it in place, and replace the seals...
J-L
----- Original Message -----
From: Rich & Lori Williams <paddlers@nwlink.com>
To: <lro@Works.Team.Net>
Sent: Sunday, June 03, 2001 12:58 AM
Subject: Re: LRO: Steering Relay Removal
> > :> Blue wrench the frame seems to be a common solution.
> > :
> > :What does this mean?
> >
> > Oxy-acetylene torch applied to the offenending cross-member, followed by
> > welding in a replacement bit.
>
>
> DUH! I should have been able to figure that out.
>
> Well hopefully there is another way. Or do you all think that covering in
> duct tape and leaving it in place during sand blasting is best?
>
>
>
>
>
This archive was generated by hypermail 2b30 : Sun Jun 03 2001 - 15:27:06 EDT