Kirk,
I used two pieces of 2x 1/4 flat about 12 inches long to bolt to the
rear of the engine then drilled 3/8 holes in them to bolt to the stand.
This allowed me to use the original bolts on the engine and regular
3x3/8 bolt in the stand
John and Muddy
Kirk Hillman wrote:
>
> They are a 3/8" shank and fine thread so if they are SAE they must be
> 3/8"-24. My engine stand has 2-3/4" of metal for the bolt to pass through
> before it even gets to the block so the little bolts that are in there
> (1-1/8" ??) are not going to cut it. ;-)
>
> Kirk
> _______________________________________________
> LRO mailing list
> LRO@land-rover.team.net
> http://land-rover.team.net/mailman/listinfo/lro
_______________________________________________
LRO mailing list
LRO@land-rover.team.net
http://land-rover.team.net/mailman/listinfo/lro
This archive was generated by hypermail 2b30 : Thu Apr 10 2003 - 09:39:08 EDT