>>I thought about applying heat, but the only applicator handy was my
>>oxy-acetylene torch, so I decided to try more conservative
>>approaches. Channel locks were a no go, as there are several studs in
>>the way, and I was too lazy to take them out. I tried a hammer and punch
>>in the groove, but I couldn't turn it that way, so it does seem to be a
>>bit tight. I awoke this morning with visions of an impact puller made of
>>1/8" x 1/2" angle iron, so that may become this afternoon's project. If
>>that doesn't work, I may resort to heat.
I tried with a couple of pry bars, but it wouldn't budge.
John Karlsson
956 Main Street
P.O. Box 1023
Hope Valley, RI 02832
_______________________________________________
LRO mailing list
LRO@land-rover.team.net
http://land-rover.team.net/mailman/listinfo/lro
This archive was generated by hypermail 2b30 : Sat Apr 05 2003 - 15:53:02 EST