Nick Danger wrote:
> I have 12V at the battery, 12V at one side of the starter coil and 12V
> at the bottom (towards the pedals) fuse. When I turn the key to 'on',
> my 12V at the bottom fuse goes to about 2v or less tho.
>
> So would that indicate a short or ground somewhere? Or did I just
> cut/break something I shouldn't have? What have I done??!
That suggests a high-resistance connection somewhere. If the ground you were
using was a good one, then there is a high-resistance joint between battery
and where you're measuring voltage. If you're not too sure of the ground you
were using check that too. Could also be a flat battery tho'
_______________________________________________
LRO mailing list
LRO@land-rover.team.net
http://land-rover.team.net/mailman/listinfo/lro
This archive was generated by hypermail 2b30 : Sat Mar 29 2003 - 18:12:00 EST