Re: [lro] special tool

From: William J. Rice (jarvis64@juno.com)
Date: Tue Jan 14 2003 - 22:36:50 EST

  • Next message: Jim Hall: "Re: [lro] special tool"

    On 14 Jan 2003 10:46:59 +0000 Ian Stuart <Ian.Stuart@ed.ac.uk> writes:
    using
    > (where the overdrive sits), you can open the tab on the locking
    > washer,
    > and then use a drift to undo the nut.
    >
    > I use an old pushrod, with the ball-end cut off. it only needs a
    > couple
    > of sharp taps to break the grip and then you can unthread it by
    > hand...

    Oh, it's already off, and I've put plenty on using the "whack a mole"
    technique but have recently had some, uh, problems, and figure, what the
    heck, I've only been doing this for about 7 years, why not use the right
    tool and torque it?
    TAW would be proud . . .

    b
    _______________________________________________
    LRO mailing list
    LRO@land-rover.team.net
    http://land-rover.team.net/mailman/listinfo/lro



    This archive was generated by hypermail 2b30 : Tue Jan 14 2003 - 21:53:11 EST