I am looking where to buy the socket tool to remove the S3 109 hub axle nut.
It's the round faced one with the slits cut into it secured with a pin. Goes
right on after the dust cap. I called a few places but no luck they keep
telling me to make one. Well I would end up buying more tools just to make
a new one.
Thanks
Mike
>From: Stirling Anderson <suntzu_2002@yahoo.com>
>Reply-To: lro@koan.team.net
>To: lro@koan.team.net
>Subject: Re: [lro] Special Purpose tools: Re: Brake pad installation:
>Date: Mon, 16 Dec 2002 11:50:12 -0800 (PST)
>
>
>--- "Alan J. Richer" <mrchurchill109@yahoo.com> wrote:
>
> > Y'know, spring tools and the like are all well and
> > good,
> > but I have a real problem dealing with "one-note
> > Johnnys"
> > in my toolbox.
>
> > Opinions?
>
>I always say... There is no substitute for the correct
>tool. Purpose made tools are great, however, they do
>tend to clog up my tool bag. So, I make due with as
>little as possible. If something is required, than
>that's all there is to it... if another can be used in
>a pinch, even better, and the purpose built tool stays
>in the basement. Stirling
>Yahoo! Mail Plus - Powerful. Affordable. Sign up now.
>http://mailplus.yahoo.com
>_______________________________________________
>LRO mailing list
>LRO@land-rover.team.net
>http://land-rover.team.net/mailman/listinfo/lro
_________________________________________________________________
Add photos to your e-mail with MSN 8. Get 2 months FREE*.
http://join.msn.com/?page=features/featuredemail
_______________________________________________
LRO mailing list
LRO@land-rover.team.net
http://land-rover.team.net/mailman/listinfo/lro
This archive was generated by hypermail 2b30 : Mon Dec 16 2002 - 16:50:46 EST