Re: [lro] T-case output shaft removal

From: Jim Hall (jimfoo@purplemountain.net)
Date: Mon Nov 04 2002 - 23:33:44 EST

Previous message: Peter Ogilvie: "RE: [lro] Parkinsons was Learning to weld?"
In reply to: Kirk Hillman: "Re: [lro] T-case output shaft removal"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

If you take the snap ring off, you don't have to remove the front race.

Kirk Hillman wrote:
>
> > did you remove the inner snap ring? It's by the front output bearing but
> > inside the case.
> Inner snap ring??? Does that answer your question? :-) I didn't see one.
> How would it stop the bearing race from being pushed out though?
>
> Kirk
> _______________________________________________
> LRO mailing list
> LRO@land-rover.team.net
> http://land-rover.team.net/mailman/listinfo/lro

-- 
Jim Hall
1966 88" Elephant Chaser
http://webs.purplemountain.net/jimfoo/Foospage.htm
"You know, I never really damaged my Rover 'till I started wheeling 
with Jim." Mitch Stockdale
_______________________________________________
LRO mailing list
LRO@land-rover.team.net
http://land-rover.team.net/mailman/listinfo/lro

Previous message: Peter Ogilvie: "RE: [lro] Parkinsons was Learning to weld?"
In reply to: Kirk Hillman: "Re: [lro] T-case output shaft removal"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

This archive was generated by hypermail 2b30 : Mon Nov 04 2002 - 23:36:56 EST