Re: [lro] T-case output shaft removal

From: Alan J. Richer (mrchurchill109@yahoo.com)
Date: Mon Nov 04 2002 - 09:07:39 EST

  • Next message: Peter Hope: "Re: [lro] Fabrication questions"

    --- Kirk Hillman <hillman88@telus.net> wrote:
    >
    > > did you remove the inner snap ring? It's by the front
    > output bearing but
    > > inside the case.
    > Inner snap ring??? Does that answer your question? :-)
    > I didn't see one.
    > How would it stop the bearing race from being pushed out
    > though?

    Because the drift you're whacking on it with is riding on
    the snap ring? (speculation)?

                ajr

    =====
    The journey is the destination. Anything else is illusion.

    Please ignore the following advertising.....
    HotJobs - Search new jobs daily now
    http://hotjobs.yahoo.com/
    _______________________________________________
    LRO mailing list
    LRO@land-rover.team.net
    http://land-rover.team.net/mailman/listinfo/lro



    This archive was generated by hypermail 2b30 : Mon Nov 04 2002 - 09:08:54 EST