TA, I think you're misunderstanding the part they're talking about (then
again, maybe I am). I noticed you mentioned roofside to body seals
before. My impression on this thread was that it was about the rubber
thingmos that go between the steel supports on a 109SW tub and the
supports that extend up from the frame. Held on by two clips each. I
re-used mine since they weren't too brittle. Used Automotive GOOP to
glue them to the gorgeous, sexy, galvanized finish of my tub supports.
Anyway, it wasn't my impression that they were talking about any sort of
seal here.
bill
> What is it about series owners that a large number of people
> immediately
> start thinking of coming up with a hack that kinda might kinda work
> as
> long as you don' want it to be pretty.
>
> Many of these same people say if you use assemblies that are not an
>
> option from the factory then you no longer own a Land Rover.
>
> So what the heck is wrong with using the genuine Land Rover body
> seals?
> I installed a new set in '98 and I do not recall them being overly
> expensive.
>
> Why bungie cord the red lever to keep it from rattling when you can
> just
> replace the cheap stock anti rattle spring?
>
>
>
>
> TeriAnn
> http://www.overlander.net
>
> The world's most complete set of links connecting Rover 4X4
> owners
> with Rover parts, service, accessory & sales companies world
> wide.
>
>
This archive was generated by hypermail 2b30 : Mon May 14 2001 - 17:42:44 EDT