Re: [lro] Series III wheel stud drill size.

From: David Scheidt (dmschei@attglobal.net)
Date: Fri Feb 21 2003 - 18:34:17 EST

Next message: Rick Grant: "[lro] Weber Carb linkage"

Previous message: Hermen Vlothuizen: "Re: [lro] Series III wheel stud drill size."
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

>Hey, finally I can ask a pertinent and useful question!
>
>What's the drill bit I need? The holes in the hub have to be enlarged for
>the splined series III studs, but to what size? I thought it was 9/16" but
>that's too small.
>

I recall using a 5/8 or thereabouts. Maybe 39/64 or 41/64.
_______________________________________________
LRO mailing list
LRO@land-rover.team.net
http://land-rover.team.net/mailman/listinfo/lro

Next message: Rick Grant: "[lro] Weber Carb linkage"
Previous message: Hermen Vlothuizen: "Re: [lro] Series III wheel stud drill size."
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

This archive was generated by hypermail 2b30 : Fri Feb 21 2003 - 20:11:42 EST