Yea, the nut wobbles up and down. Straight out of the box they had a loose,
easy to turn fit; after tapping/di-ing I could grab the nut and rock it back
and forth.
Casey
David Scheidt <dscheidt@tumbolia.com> wrote:
> On 7 May 2001, Casey McMullen wrote:
As a test I ran the tap through a
> :new nut, and ran a new bolt through the die. When fitted they had an
> :extremely loose fit. Is the trick to only run the cutting edges part way
> :through?
>
> Loose which way? Too easy to spin on, or is there longitudal movement?
> ... The nut shouldn't wobble up and down though.
____________________________________________________________________
Get free email and a permanent address at http://www.amexmail.com/?A=1
This archive was generated by hypermail 2b30 : Tue May 08 2001 - 15:08:02 EDT