If any one knows of proper linkage, I would appreciate a pic or some help as
well. I have rochester and a hand throttle, and it runs and all, but I
always wondered if it was really set up right. Some things just don't seem
to fit right. Of course all of this could be due to the PO who installed it,
but again all help would be very appreciated.
Matthew Kohr
1961 88 SWB SW
----- Original Message -----
From: "Ben Mitchell" <ben@mitchellfamily.com>
To: <lro@Works.Team.Net>
Sent: Wednesday, April 04, 2001 4:50 PM
Subject: LRO: Rochester carb help...
>
> Hi folks,
>
> I'm in the process of completely renovating a dilapidated 88", and I've
> opted to install a Rochester carb. It's all bolted in, but I can't figure
> out how the linkages are supposed to be set up. Does anyone have (a) a
> Rochester carb installed on his truck and (b) a digital camera with which
he
> could provide some photographic guidance about the right way to connect
> everything? Of course any narrative guidance would be greatly appreciated
> as well, but as they say: a picture says a thousand words.
>
> Best,
>
> -Ben Mitchell
> 1970 SIIA 88"
> 1994 D90 4.6L (hey, at least it's a Rover powerplant ;-)
>
This archive was generated by hypermail 2b30 : Thu Apr 05 2001 - 00:37:04 EDT